Gazebo DIY kits are a beautiful structure present in gardens that allow the plant to become entangled in it. When the vine takes over the entire structure, it provides a shaded passage leading to the garden. A gazebo can even be placed in the center of the garden to act as the main point .Place four 2 x 4 inches (5 x 10 cm) tables in the area where you want to build the gazebo. This will determine the size of the pergola. Use the form work square to square each corner. Mark the position of the boards with chalk or spray paint.
Gazebo DIY kits, dig a 3.5-foot hole to place a pole at each of the four corners. This hole should be approximately 6 inches in diameter and 3.5 feet in depth. You can do it with a bulldozer, but an electric bit is more efficient. The latter can be rented at a home improvement store. Place 2 inches of broken stone at the base of the four posts. This will allow the drainage of water once the posts have been placed. Place a 2 x 4 and 8 ft long pressure treated wood inside each hole. Use a level to make sure they are in a completely upright position.
12 Photos Gallery of: Ideas Gazebo DIY Kits
Gazebo DIY kits clamp one end of a 2 x 4 board to the top and bottom of each post and nail the opposite side of the board to the adjacent post. This will create a support at the top and bottom of each of the posts to keep them level while the concrete dries. Check the level and move the poles if necessary. Fill the holes in the posts with quick-drying concrete. This does not need to be mixed. Put water in the holes on the concrete, using a hose. The concrete will begin to absorb it. Do not fill the hole too much. If water is added too quickly, it will start to soak. Remove the hose and wait for the concrete to absorb it. When you no longer absorb, you will be finished. Let it cure for 30 minutes. Be sure to check the level and move the posts if necessary.