Railroad ties for landscaping – Starting with lay out railroad ties in the shape you have planned. When you secure the railroad ties into the ground, moving them will be difficult. Lay the straps out as a dry drive. Before you make sure them to the earth, move them around and make the necessary cuts. Then, decide how high you want. The railroad ties bed to be. Do you want the highbred higher than the height of a railroad tie, about six inches? Then you will have to stack two or more railroad tracks on top of each other.
Drill a hole at each end of the belt railroad ties for landscaping as well as every four feet down the length. Drill evenly spaced holes along the length of the railroad spines, if the length of the tie is not divisible by 4. About every three to five feet. The higher the wall or the more weight it will support. The closer you should place the anchoring holes. Drive reinforcing iron or any other type of metal game. These through each hole in the railway tree and then into the ground below. The iron should be twice as long as the expected height of the wall.
6 Photos Gallery of: To Secure Railroad Ties for Landscaping
This allows you to sink the reinforcing iron in the ground at the same depth. Like the height of the wall. Placer reinforcement iron through the hole in the rail tie and pound it into the ground. If you stack more than one rail tie, the ties have stacked before you start thumping. Do not stop before the reinforcement iron flies with the railroad tie. Repeat as needed. When you have one end of the railroad tie in the ground, move to the next spot on draw. Repeat until you secure the belt railroad ties for landscaping all the way around the perimeter.